924 replies to this topic

[Eski]

Yes ray is right, standard open diff

[JihadJoeJr]

S0unIQ, on 17 February 2012 - 12:16 PM, said:

Pretty sure standard 3.9 as he's always had an open.

Eski, on 17 February 2012 - 01:40 PM, said:

Yes ray is right, standard open diff

Cheers for confirming fellas

he did have ++1 up with high stall, something I'm not yet keen to do so will see what it does.

Also Projectors are completed..







There isn't any light strip on that shroud, just the chrome bits reflecting off the halo led.

Not going on for a little while though.. got some other bits to do upfront.

[KRaZi]

You cant sit it further back and just paint the reflector black? the reflector wouldnt interfer with the beam.. or is it an issue of the length of the projector housing coming out the back too far?

[JihadJoeJr]

KRaZi, on 17 February 2012 - 08:54 PM, said:

You cant sit it further back and just paint the reflector black? the reflector wouldnt interfer with the beam.. or is it an issue of the length of the projector housing coming out the back too far?

this is the bit that shines and I don't really want to spray it





also the chrome reflector is sprayed black



It sits fine as is - I just need to get the led circular lights for the high beam - but that's later down the track. Exhaust next Sunday... no screamer as per a few good mates advice.

[JihadJoeJr]

so anyways,

old ballast..


new ballast..










the motors work with level adjustment didn't realize it would, til I plugged the motor in LOL..

Dropping in @ exhaust place tomorrow morning - finally xD, been caught up @ work and the fellas were busy too.

*edit* quick picture just before the car went away.

[adam]

That is awesome dude, doesn't look to have any glare whatsoever! I will definitely be considering a retrofit sometime when I get my hands on a cheap set of lights!

[FRpilot]

dam rizz u killin it with that mod

[ToF]

That's awesome stuff riz, perfect cut off.

[S0unIQ]

Oh yeah! wicked cutoff.

[JihadJoeJr]

updates:

4" dump pipe -> 3.5" -> mid section muffler -> resonator -> straight outlet. Put a bung in the cooler pipe to be able to accurately measure pressure drop.. should this increase more than 2psi under boost, will change the cooler core to something beefier - plenty of room if you trim the front bar..

Feels more responsive but I dare not give it the full beans as afrs show it close to leaning out - there is slight drone yes but when its cruising then no dramas.

I really need kit now..




The projectors, foggies are being put back together after being cleaned out.





tradesecret Josh pwning me in my own damn camry... sucks not being able to smash the throttle..



Time for final tune and thats 1j tuning DONE ...oh and this can be made into a screamer too... remove plate and - for now plumb back til tune done.

oh and replaced nuts to black!