62 replies to this topic

[HIZOKU]

SO this is what i got done before it started to rain........



Bolted this up.....


It joins to this..



my new tires and roughly where there sitting atm






OLD tires on passanger side vs new tires on driver side

Driver side are 17 x 9 +18 with a 255 40 on it and passanger side is a 8.5 +25 with a 235 45 on it



Old tire placed back on just to sit on..... cross member sitting at about 130mm off the ground still have two inchs of adjustment to lower the coilovers but yeah once kit is fitted i think it will be low enough.



But yes it ROLLING again. so it been some time but im happy where it is at.. just need to connect sway bars and give it a alignment and work out what i will do from there

[HIZOKU]

Bit of a update.

Not to much happen on the weekend swapped rear door handle over started stripping engine to clean it up and replace water pump belts and so on.

and gave my car a alignment to find a problem... Some reason my LCA are different from stock X81 and are like a cross between X81 and S13 items. so i need to change a couple parts on them. (remove bump stop) as my tie rod end was hitting my LCA resulting in me not getting any wear near as much lock as i use to get also need to extend my tie rod end a fair bit more. a good 6cm minimum so have full adjustment of alignment.

[HIZOKU]

Issue is X7 rack is 30MM shorter then X8 rack so my legnth of stock items to 30+mm was pointless and now i have to extend another 20mm min 30MM be ok 50MM awesome LOL